Epson S2R72V18 Technical Manual page 124

Timing
Parameter
T0 Stops operation for the state being executed. (F/W)
T1 Checks that the host state change execute cancel bit is "0," and
sets H_NegoControl_0.AutoMode to "GoIDLE." (F/W)
Switches off VBUSEN_A.
Sets the transceiver selection to FS mode.
Sets the terminal selection to FS mode.
Sets the operating mode to "NonDriving."
Immediately stops the transaction execute function.
Disables connect detection, disconnect detection, remote
wakeup detection, and device chirp detection. (H/W)
S2R72V18 Technical Manual (Rev.1.00)
Table 1-41 GoIDLE timing values
Description
EPSON
1. Functions
Value
0 (reference)
T0 + 5cycle (60 MHz) < T1
107