Wiring Of Ethernet Cable - Mitsubishi Electric NZ2MF2S1-32D User Manual

Wiring of Ethernet cable

Wiring method
■Installation method
1.
Power off the power supplies of the I/O module and the external device.
2.
Push the Ethernet cable connector into the I/O module until it clicks. Pay attention to the connector's direction.
3.
Power on the module power supply of the I/O module.
4.
Power on the external device.
5.
Check if the 100M LED on the port into which the Ethernet cable is connected is on.
*1 The time taken for the 100M LED to turn on after connection of the Ethernet cable may vary. The 100M LED normally turns on in a few
second. However, if link-up processing is repeated due to a condition of a device on the line, the longer time may be required. If the
100M LED does not turn on, refer to the following and take a corrective action.
Page 99 When the 100M LED turns off
■How to disconnect
1.
Power off the module power supply of the I/O module.
2.
Press down the latch of the Ethernet cable and unplug the cable.
Precautions
For precautions when wiring the Ethernet cable, refer to the following.
 CC-Link IE Field Network Basic Reference Manual
* 1
6 INSTALLATION AND WIRING
6.5 Wiring
6
79