Qiagen EZ2 Connect MDx User Manual page 48

To unpack the EZ2:
1. Before unpacking the EZ2, move the package to the site of installation and check that the
arrows on the package point upward. In addition, check whether the package is damaged. In
case of damage, contact QIAGEN Technical Services.
2. Open the top of the transportation box and remove the top layer (PE foam).
3. Remove the accessories box together with the PE foam at its perimeter.
Figure 20. Accessories box.
4. Remove the outer carton box by holding at the cut-out area and lifting up the outer carton box.
5. Remove the two pieces of protector from the unit.
6. Move the unit to the workbench or trolley from the packaging. When lifting the EZ2, slide
your fingers under the side of the instrument and keep your back straight.
Important: Two persons are required to lift the EZ2.
Important: Do not hold the touchscreen display while unpacking or lifting the EZ2, this might
damage the instrument.
7. Remove the foam strip which is placed in the gap between the hood and the front top cover.
8. Remove the pieces of tape which secure the hood to the base panels.
9. Remove the protective film which covers the hood
10. Open the hood and remove the transport lock from the pipetting head by pulling the transport
lock from bottom.
EZ2 Connect MDx User Manual 05/2022 48