Table of Contents
Advertisement
14. Install the access panel.
15. Install the server into the rack.
16. Connect all peripheral cables to the server.
17. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
18. Power up the server.
19. If removed, install the security bezel.
The installation is complete.
M.2 SATA SSD enablement option
The server supports the installation of M.2 SATA SSD enablement board. The enablement board can support two M.2
SATA SSDs.
Use the embedded HPE Smart Array S100i SR Gen10 Controller to manage the M.2 SATA SSDs. The S100i SR Gen10 SW
RAID support requires that the server boot mode be set to UEFI.
Installing an M.2 SATA SSD
The M.2 SATA expansion board supports 2280 or 22110 M.2 SSDs only.
Prerequisites
Before you perform this procedure, make sure that you have the following tools available:
•
T-15 Torx screwdriver
•
Phillips No. 1 screwdriver
82
Hardware options installation
Hide quick links:
Advertisement
Table of Contents
