Figure 3-85 Select File Window; Figure 3-86 Mef Loading - Siemens GCP5000 Instruction & Installation Manual

_________________________________________________________________________________________________________
8. The Select File window opens. Scroll down to select the file to be installed, in this
example GCP04_50.MEF. Select Enter.
9. The new MEF begins loading. This may take a few minutes. While the file is
downloading, progress will be indicated on the bottom line of the window.
10. When complete, the Display text provides all of the module update options. Select 0)
Exit Setup. The Upload to System window opens and states: Exit software finished
rebooting the module.
11. Press the Back button.
12. If there are other PSO modules in the system, repeat the procedure for those modules
as well.
3.4.4 Installing Software on RIO Module
To install the MEF files on the RIO Modules.
Perform the following actions:
1. Insert USB Drive in the USB slot on the front of the Display.
2. If Maintainer security has been enabled, enter the password. The password is case
sensitive. If security is not enabled, proceed to step 3.
3. Connect the serial cable between the Diag port on the Display and the DIAG port of the
RIO module to be updated.
SIG-00-22-02
Version: B.1
DISPLAY MODULE AND OFFICE CONFIGURATION EDITOR

Figure 3-85 Select File Window

Figure 3-86 MEF Loading

3-53
JUNE 2022 (Revised September 2022)