Siemens GCP5000 Instruction & Installation Manual page 87

_________________________________________________________________________________________________________
Router Settings Screen
The Router Settings screen enables the user to set the parameter Route Table Entry Timeout,
measured in milliseconds.
Log Setup Screen
The Log Setup screen has the following submenus. These are used to set various levels of
diagnostic level message tracing and debugging and are generally for Siemens personnel use:
•
Consolidated Logging, which sets the Event and Diagnostic Log IP Addresses of the target
system to send log events to.
•
Diagnostic Options, which opens, setting the following parameters of the Diagnostic Log:
The following parameters are for Siemens use, for message tracing. These should be set to
disabled unless specifically advised by Siemens. Setting them to enabled can slow down the
performance of the system:
•
Message Processing (Layer 7)
•
Routing (Layer 3)
•
Serial Port 1 TX/RX (Layer 2)
•
Ethernet Laptop Port RX/TX (layer2)
•
Ethernet Port 1 RX/TX (layer2)
•
Ethernet Port 2 RX/TX (layer2)
•
®
Echelon RX/TX
•
CPU III RX/TX
Logging Verbosity
Display Diagnostic Log Verbosity:
•
Basic
•
Error
•
Warning
•
Info
•
Debug
SIG-00-22-02
Version: B.1
DISPLAY MODULE AND OFFICE CONFIGURATION EDITOR
3-23
JUNE 2022 (Revised September 2022)