Siemens GCP5000 Instruction & Installation Manual page 439

_________________________________________________________________________________________________________
crossing logic they need to be tied in with the receivers used on the PSO module set in crossing
Mode, or fed into the crossing logic in another manner (see Section 10.1.2.1 regarding PSO
receiver Enable)
The following additional parameters are available on this screen in this mode:
•
TX Freq Category: range Standard, Alternate, default Standard
•
TX Frequency: range see below, default Not Set
•
TX Transmit Level: range Low, High, default Low
•
TX Address: range A, C, D, E, F, Dynamic, default A
•
Tx Enabled Used: range Yes, No, default No
•
Wrap Pickup Delay: range 0-10 sec, default 5 sec, as described previously.
The following standard Siemens frequencies can be selected when the Tx Freq Category is set
to standard:
156 Hz 211 Hz
790 Hz 970 Hz
4.0 kHz
The following alternate Siemens frequencies can be selected when the Tx Freq Category is set
to alternate:
500 Hz 700 Hz
1.5 kHz 1.64 kHz
2.8 kHz 3.1 kHz
6.4 kHz 7.1 kHz
See the PSO 4000 manual (SIG-00-07-06) for instructions on frequency selection and transmit
level settings.
The transmitter can be set up to send a fixed code of A, C, D, E, or I or it can be set to Dynamic
mode where the code transmitted is set vital inputs (or logic). When TX Address is set to
Dynamic the following inputs are available in the set of System Inputs (where n = 1..5):
•
PSO n TX Code A
•
PSO n TX Code C
•
PSO n TX Code D
•
PSO n TX Code E
•
PSO n TX Code F
When Dynamic mode is used a configured pickup delay is available as shown in Figure 10-12.
•
Tx Enable Pickup Delay: range 0-30 sec, default 0 sec
When a TX Address used a fixed code, the Tx Enable Used option is available. When this is set
to Yes, one of the PSO n TX Code A .. F inputs can be mapped to an input, which one depends
upon the fixed code selected.
SIG-00-22-02
Version : B.1
285 Hz 348 Hz
1.18 kHz 1.45 kHz
900 Hz 1.0 kHz
1.75 kHz 1.875 kHz
3.5 kHz 4.0 kHz
7.7 kHz 8.3 kHz
10-15
430 Hz 525 Hz
1.77 kHz 2.14 kHz
1.125 kHz 1.3 kHz
2.175 kHz 2.3 kHz
4.9 kHz 5.4 kHz
8.9 kHz 9.5 kHz
JUNE 2022 (Revised September 2022)
MENU MAPS
645 Hz
2.63 kHz
1.37 kHz
2.675 kHz
5.9 kHz
10.2 kHz