Table 8-6 Cpu Iii Gcp Display Messages - Siemens GCP5000 Instruction & Installation Manual

DETAILED CASE AND MODULE DESCRIPTION
_________________________________________________________________________________________________________
Display
GCP5000 Scrolling
BOOT Steady
CRC* Steady
MCF* Steady
SIN* Steady
VLP UCFG Scrolling
VLP INITIAL Scrolling
BURNING MCF Scrolling
NO VLP COMMS Scrolling
ERASING THE ECD Scrolling
ADR* Steady
INI* Steady
Exxx Steady
LMCF Steady
ICHK Steady
SIG-00-22-02
Version: B.1

Table 8-6 CPU III GCP Display Messages

Mode Meaning
VLP is healthy
CPU is booting up.
MCF CRC is incorrect for the
current MCF
CPU is not healthy because the
MCF is not valid.
The site Identification Number is
invalid.
VLP is unconfigured.
The CP is transferring the
configuration from NVRAM to the
VLP.
The CP is copying the MCF from
the ECD into flash memory.
The CP is not communicating
with the VLP.
VLP could be rebooting or
performing its initial configuration
checks
Erasing its flash memory in
preparation for copying the MCF
from the ECD into flash memory.
The Vital comms neighbor ATCS
address is invalid
Rebooting
Internal error, System will reboot.
xxx is 3 digit hex number
Rebooting
Rebooting
CPU is healthy.
CPU is booting up. Crossing is
activated.
Entered CRC does not match the CRC
of MCF. Crossing is activated.
Reboot CPU or reload MCF. Crossing is
activated.
Enter valid SIN.
Crossing is activated.
No comm to I/O modules.
Crossing is activated.
No comm to I/O modules.
Crossing is activated.
No comm to I/O modules. Crossing is
activated.
No comm to I/O modules. Crossing is
activated.
No comm to I/O modules.
Crossing is activated.
Address of Vital comms session cannot
be computed. Enter valid SIN
System Reboot -
Crossing is activated.
Reload MCF -
Crossing is activated.
System Reboot -
Crossing is activated.
System Reboot -
Crossing is activated.
8-12
JUNE 2022 (Revised September 2022)
System State