Table of Contents
Advertisement
CAUTION: Default password is "00318", user can change it in case of others change the advanced parameters setting. Please
clearly remember the password after changing. If you forget it, please contact SmartGen services and send all information in the
controller page of "ABOUT" to us.
5.3 LCD DISPLAY
5.3.1
MAIN DISPLAY
Main screen show pages; use
★Main Screen, including as below,
Gen: voltage, frequency, current, active power, reactive power;
Bus: voltage, frequency;
Engine: speed, temperature, oil pressure;
Some status.
★Status, including as below,
Status of genset and ATS.
★Engine, including as below,
Engine speed, engine temperature, engine oil pressure, fuel level, flexible sensor 1, flexible sensor 2, battery
voltage, charger voltage, engine accumulated run, accumulated start times.
NOTE: If connected with J1939 engine via CANBUS port, this page also includes: coolant pressure, coolant level, fuel
temperature, fuel pressure, inlet temperature, exhaust temperature, turbo pressure, total fuel consumption and so on. (Different
engine with different parameters).
★Generator, including as below,
Phase voltage, line voltage, frequency, phase sequence, current, each phase and total active power (positive
and negative), each phase and total reactive power (positive and negative), each phase and total apparent
power, each phase and average power factor (positive and negative), accumulated energy (kWh, kVarh, kVAh),
multi power, earth current, unbalanced current.
NOTE: Power factor shows as following,
HGM9510 Genset Parallel Controller User Manual
to scroll the pages and
Remark:
P stands for active power;
Q stands for reactive power.
to scroll the screen.
Page 13 of 68
Advertisement
Table of Contents
