User Menu And Parameters Setting Menu - Smartgen HGM9510 User Manual

Power
Conditions
Factor
COS>0L P>0,Q>0
COS>0C P>0,Q<0
COS<0L P<0,Q>0
COS<0C P<0,Q<0
NOTE:
1. Input active power, generator sends electricity to load.
2. Output active power, load supplies electricity to generator.
3. Input reactive power, generator sends reactive power to load.
4. Output reactive power, load sends reactive power to generator.
★Bus, including as below,
Phase voltage, line voltage, frequency, phase sequence.
★SNYC, including as below,
Volt difference, freq difference, phase difference, active power percentage, target active power percentage,
reactive power percentage, target reactive power percentage, GOV percentage, AVR percentage and MSC
status.
★Alarm:
NOTE: For ECU alarms and shutdown alarms, if the alarm information is displayed, check engine according to it, otherwise,
please check the engine manual according to SPN alarm code.
★Event log
Make records about all start/stop events (shutdown alarm, trip and stop alarm, manual/auto start or stop) and
the real time when alarm occurs.
★Others, including,
Time and date, maintenance due, input/output ports status.
★About, including,
Issue time of software and hardware version, product PD number.
5.3.2

USER MENU AND PARAMETERS SETTING MENU

Press key for more than 3s to enter into user manual.
Parameter

After entering the correct password (factory default password is 00318) you can enter parameter settings
screen.
Language

Selectable Chinese, English and others (default: Espanol)
Commissioning

HGM9510 Genset Parallel Controller User Manual
Table 7 Power Factor Description
Active Reactive
Power Power
Input Input
Input Output
Output Input
Output Output
Remark
Load is inductive resistance.
Load is capacitance resistance.
Load is equal to one under excitation generator.
Load is equal to one over excitation generator.
Page 14 of 68