Connections Of Controller With J1939 Engine; Cummins Isb/Isbe; Cummins Qsl9; Cummins Qsm11 (Import) - Smartgen HGM9510 User Manual

16 CONNECTIONS OF CONTROLLER WITH J1939 ENGINE

16.1

CUMMINS ISB/ISBE

Terminals of controller
Fuel relay output
Starting relay output
Programmable output 1
Terminals of controller
CAN GND
CAN(H)
CAN(L)
Engine type: Cummins ISB.
16.2

CUMMINS QSL9

Suitable for CM850 engine control module.
Terminals of controller
Fuel relay output
Starting relay output
Terminals of controller
CAN GND
CAN(H)
CAN(L)
Engine type: Cummins-CM850.
16.3

CUMMINS QSM11 (IMPORT)

It is suitable for CM570 engine control module. Engine type is QSM11 G1, QSM11 G2.
Terminals of controller
Fuel relay output
Starting relay output
HGM9510 Genset Parallel Controller User Manual
Table 19 Connector B
Connector B
39
-
Expand 30A relay, battery
voltage of 01, 07, 12, 13 is
supplied by relay.
Table 20 9-pin Connector
9 pins connector
SAE J1939 shield
SAE J1939 signal
SAE J1939 return
Table 21 50-pin Connector
50 pins connector
39
-
Table 22 9-pin Connector
9 pins connector
SAE J1939 shield-E
SAE J1939 signal-C
SAE J1939 return-D
Table 23 C1 Connector
C1 connector
5&8
-
Remark
Connect with starter coil directly.
ECU power;
Set programmable output 1 as "ECU power".
Remark
CAN communication shielding line (connect
with ECU terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
Connect to starter coil directly.
Remark
CAN communication shielding line (connect
with ECU terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
Outside expand relay, when fuel output,
making port 5 and port 8 of C1 be
connected.
Connect to starter coil directly.
Page 59 of 68