Cummins Qsx15-Cm570; Cummins Gcs-Modbus - Smartgen HGM9510 User Manual

Terminals of controller
CAN GND
CAN(H)
CAN(L)
Engine type: Cummins ISB.
16.4

CUMMINS QSX15-CM570

It is suitable for CM570 engine control module. Engine type is QSX15.
Terminals of controller
Fuel relay output
Starting relay output
Terminals of controller
CAN GND
CAN(H)
CAN(L)
Engine type: Cummins QSX15-CM570.
16.5

CUMMINS GCS-MODBUS

It is suitable for GCS engine control module. Use RS485-MODBUS to read information of engine. Engine types
are QSX15, QST30, QSK23/45/60/78 and so on.
Terminals of controller
Fuel relay output
Starting relay output
Terminals of controller
RS485 GND
RS485+
RS485-
Engine type: Cummins QSK-MODBUS, Cummins QST-MODBUS, Cummins QSX-MODBUS.
HGM9510 Genset Parallel Controller User Manual
Table 24 3-pin Data Link Connector
3 pins data link connector
C
A
B
Table 25 50-pin Connector
50 pins connector
38
-
Table 26 9-pin Connector
9 pins connector
SAE J1939 shield-E
SAE J1939 signal-C
SAE J1939 return-D
Table 27 D-SUB Connector 06
D-SUB connector 06
5&8
-
Table 28 D-SUB Connector 06
D-SUB connector 06
20
21
18
Remark
CAN communication shielding line (connect
with ECU terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
Oil spout switch.
Connect to starter coil directly.
Remark
CAN communication shielding line (connect
with ECU terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Remark
Outside expand relay, when fuel output, making
port 05 and 08 of the connector 06 be
connected.
Connect to starter coil directly.
Remark
CAN communication shielding line (connect
with ECU terminal only).
Using impedance 120Ω connecting line.
Using impedance 120Ω connecting line.
Page 60 of 68