Table of Contents
Advertisement
8
PARAMETERS SETTING
8.1 SETTING MENU
Start the controller, then press
8.2 PARAMETERS SETTING
When entering password interface, inputting "1234" can set part of the parameter items in 7.1 while
"0318" can set all the items. If there is need to set more parameters (e.g. voltage calibration; current
calibration), please contact the factory.
Note:
1. Please change the controller parameters when generator is in standby mode only (e. g. Crank
disconnect conditions selection, auxiliary input, auxiliary output, various delay), otherwise,
shutdown and other abnormal conditions may occurs.
2. Over voltage set value must be higher than under voltage set value, otherwise over voltage and
under voltage condition may occur simultaneously.
3. Over speed set value must be higher than under speed set value, otherwise over speed and under
speed condition may occur simultaneously.
4. Please set the generator frequency value as low as possible when cranking, in order to make the
starter be separated quickly as soon as possible.
5. Auxiliary input 1~4 could not be set as same items; otherwise, there are abnormal functions.
However, the auxiliary output 1~5 can be set as same items.
6. If need to shut down after cooling, please set any auxiliary input as "High Temperature Stop Input",
then connect this input port to GND.
8.3 INFORMATION
LCD will display software version, issue date of the controller.
Note: In this interface, press
8.4 LANGUAGE
Simplified Chinese, English, Spanish, Russian and Turkish interface can be selected.
8.5 MODE
Manual mode, Auto mode and Stop mode can be selected via this interface.
Note: Pressing
HGM410DC Genset Controller
to enter into the parameters setting menu, see fig below:
1
Set Parameters
2
Information
3
Language
4
Mode
will display the auxiliary inputs and outputs status.
key at any time will quit the setting and return to the previous setting menu.
2015-11-12
HGM410DC Genset Controller User Manual
Version 1.0
Page 28 of 34
Advertisement
Table of Contents
