Configuring General Audio Settings; Setting The Volume On An External Audio System - Polycom V500 Administrator's Manual

Administrator's Guide for the V500 System

Configuring General Audio Settings

Setting the Volume on an External Audio System

4 - 10
To configure general audio settings:
1. Go to System > Admin Settings > Audio.
2. Configure these settings:
Setting
Master Audio Volume
Sound Effects
Volume
Incoming Video Call
User Alert Tones
Bass
Treble
Mute Auto-Answer
Calls
Enable Internal
Ringer
If you have connected an external audio system, you may need to adjust its
volume.
To set the volume:
Go to System > Diagnostics > Audio > Speaker Test.
1.
2. Adjust the external audio system's volume so that the tone is as loud as a
person talking in the room.
After you do this, you can adjust volume levels using the V500 system's remote
control.
Description
Sets the volume level for audio from the far site.
Sets the volume level of the ring tone and user alert tones.
Specifies the ring tone used for incoming calls.
Specifies the tone used for user alerts.
Sets the volume level for the lower frequencies without changing
the master audio volume.
Sets the volume level for the higher frequencies without
changing the master audio volume.
Specifies whether to mute incoming calls.
If you select this option, incoming calls are muted until you press
the Mute button on the remote control.
Specifies an additional ring tone when receiving an incoming
call.
The ringer is built into the system and will alert you to incoming
calls even if the TV monitor connected to the system is powered
off.
www.polycom.com/videodocumentation