Advantech VisionNavi User Manual page 70

Wait condition
Processing stops until the specified condition is satisfied.
Use this tool to synchronize when using multiple cameras.
Processing condition
[Target]
WAIT specified time
···················Wait for the specified wait time.
External input monitoring
···················Wait until the control input is on or off.
DM monitoring
···················Wait until the logic of the specified DM is established.
Camera end monitoring
···················When using the multiple cameras and operating the camera in the syn-
chronous mode (independent control OFF), wait until the process flow of the target
camera ends.
Sync event monitoring
···················When the camera is operated in synchronous mode (independent con-
trol OFF), wait until a synchronization event is issued from the processing flow of
another camera.
[Latency (ms)]
You can set the waiting time in 1 ms increments for up to 10 seconds.
[DI]
Specify the number of the control input.
[Monitor logic]
ON ··············Wait until the control input is turned on.
OFF ············Wait until the key entry is turned off.
[DM]
Specify the DM number.
[Monitor logic]
It is possible to monitor whether the DM value is other than 0 or 0 to 19.
[Post process]
After processing, you can change the value of DM as necessary.
reset ·················Set the DM value to 0.
increment ·····Increase the value of DM by 1.
decrement ····Decrement the value of DM by 1.
[Timeout(ms)]
VisionNavi User Manual 64