Attaching With Two-Point Hitch - MacDon R113 Operator's Manual

6. Position driveline (A) onto tractor power take-off (PTO).
7. Pull back collar (B) on driveline (A), and push driveline
until it locks. Release collar.
8. Route safety chain (C) from mower conditioner through
chain support (D) on drawbar hitch adapter and around
tractor drawbar support. Lock hook on chain.
NOTE:
If the tractor has a three-point hitch, lift the links as
far as possible to prevent damage to the hitch.
9. Raise jack (A), and remove pin (B).
10. Move jack (A) to storage position on top of hitch, and
secure with pin (B).
11. Proceed to
3.8.3 Connecting Hydraulics, page

3.8.2 Attaching with Two-Point Hitch

Follow these steps to attach the Category II, IIIN, and III two-point hitches:
CAUTION
Shut off tractor, engage parking brake, and remove key before working around hitch.
169820
OPERATION
Figure 3.25: PTO Driveline
Figure 3.26: Hitch Jack
49.
Figure 3.27: Jack Storage
45
Revision A