Attaching With Two-Point Hitch - MacDon R113 Installation Instructions Manual

6.1.2 Attaching with Two-Point Hitch

Follow these steps to attach category II, IIIN, and III two-point hitches:
WARNING
To avoid bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key before making adjustments to the machine.
1. Position tractor and align tractor hitch arms (A) with hitch
adapter (B).
2. Shut down the engine, and remove the key from
the ignition.
3. Remove lynch pins (C) and washers from the hitch adapter.
4. Secure hitch arms (A) onto adapter pins (D) with lynch
pins (C).
NOTE:
If the tractor is equipped with a category III hitch, use a
bushing (MD #224322) on each hitch pin (D).
NOTE:
If using a category III hitch, a longer driveshaft may be
required.
5. Install anti-sway bars (not shown) on the tractor hitch to
stabilize lateral movement of hitch arms (A). For
instructions, refer to your tractor operator's manual.
214633
REFERENCE
Figure 6.19: Two-Point Hitch Configuration
68
A
C
B
D
Revision C