Attaching With Two-Point Hitch - MacDon R113 Assembly Instruction Manual

10. Move jack (A) to storage position on top of hitch, and
secure with pin (B).
11. Proceed to 5.3.3 Connecting Hydraulics, page

5.3.2 Attaching with Two-Point Hitch

If the pull-type was configured for a tractor with a two-point hitch, then the pull-type can now be attached to the tractor.
DANGER
To avoid bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key before making adjustments to the machine.
1. Position the tractor and align hitch arms (A) with hitch
adapter (B).
2. Shut down the engine, and remove the key from
the ignition.
3. Remove lynch pins (C) and washers from the hitch adapter.
4. Secure hitch arms (A) onto adapter pins (D) with lynch
pins (C).
NOTE:
If the tractor is equipped with a category III hitch, use a
bushing (MD #224322) on each hitch pin (D). Two bushings
(MD #224322) are included with the two-point hitch
assembly.
NOTE:
If using a category III hitch, a longer driveshaft may be
required.
5. Install anti-sway bars (not shown) on the tractor hitch to
stabilize lateral movement of hitch arms (A). For
instructions, refer to your tractor operator's manual.
215585
CONNECTING THE TRACTOR TO THE ROTARY DISC PULL-TYPE
106.
Figure 5.8: Drawbar Jack Storage
Figure 5.9: Two-Point Hitch Configuration
103
Revision A