Table of Contents
Advertisement
67
Part I
Radio Operation
1.Press the
button to power on.
2.Press the BND button to choose a wave band
among FM1 FM2 FM3 AM1 and AM2.
The frequency ranges of FM1 FM2 and FM3
are identical (87.5-108MHz).
The frequency ranges of AM1 and AM2 are
identical (522-1620KHz).
3.Press the
and
button to adjust the
station that you want.
Press the
and
button to auto scan stations.
Press and hold the
and
button to manual
adjust stations. Press the and button to increase or
decrease one step, FM:0.05MHz;AM:9KHz;Press
and hold the
and
button to incessantly scan
stations until release the button. The manual
adjust state will exit without any operation in 5
seconds. The function of right knob is same as
the
and
button.
4.Press the VOL- and VOL+ button to adjust volume.
5.It will still stay on the former status when
turn off on receiving and turn on again.
If the station is broadcasted in stereo and the
signal is good, the indication sign "
light on, otherwise the indication sign "
flash, press and hold the BND button to convert
to the single track mode, the " MON" will light
on. This operation can improve the effect of
receiving. Press the BND button again to cancel.
6.Press the SCN button to scan stations in a
band, press again to stop and stay on current
frequency. Press and hold the SCN button to
switch 1 ong&short range, the "LOC" will
display on LCD when short range is effecive.
" will
" will
Advertisement
Table of Contents
