Geely MK Series Owner's Manual page 168

161
Part VI
Replace Engine Oil
First place a container for discarded oil under
the engine oil pan, unscrew the oil plug. When
oil is drained, unfasten the oil filter with a
wrench and remove it (see illustration below).
Oil Filter
Put a little oil on the rubber gasket of new oil
filter, and fasten the new oil filter till the rubber
gasket touches the seat, and rotate another 3/4
cycle to fix it. Put the drain plug and new gasket
back, and screw the plug tightly with a wrench.
After filling the oil, fasten the oil filler cap, and
check the oil level with indicator. (See illustra-
tion below).
Engine oil dipstick
Low Level
Full Level
Add Oil
Correct
When engine is cranking, the oil filter and
drain plug should not see any seepage. Seep-
age means improper installation.
Switch off the ignition, wait for 3 minutes, and
check the engine oil level again. Add more oil
when necessary.
Notice
The oil consumption of new vehicles af-
ter certain miles can be minimum, while
within the first 5000 km, the consumption
will be a little higher than standard value.
Transmission Oil
Transmission
Vehicle
oil volume(L)
model
JL7132U
2.1～2.25
JL7152U
Vehicles with
Overfilled
MT
JL7162U
3.2
JL7132HU
Vehicles with
JL7152HU
AT
Transmission oil level should be between
holes #3 and #4. (At the bottom is #1 hole,
see illustration below)
Transmission lubricant(L)
Class Viscosity
SAE
API GL-4
75W/90
Spec：DEXRONⅡ
or DEXRONⅢ