Table of Contents
Advertisement
35
Part I
You have to keep the waist belt low to the but-
tocks. Do not fasten it to the waist. Then pull
the shoulder part upward by the snib and adjust
the seat belt to proper position.
When releasing the seat belt, press the release
button on the seat belt and the belt will be re-
tracted automatically.
If the seat belt can not be retracted smoothly,
you should pull it out, and check it for knot or
distortion, make sure it is not distorted when
retracted in.
Warning
Make sure the shoulder belt go
through the center of the shoulder. The
seat belt must be a little far from the
neck, but do not let the seat belt fall
from the shoulder, otherwise it will im-
pair the protection effect and may result
in bad injury in case of unexpected ac-
cidents or collisions.
High-level waist belt and loose seat
belt may result in its sliding under the
waist belt and cause bad injury in case
of collisions or other unexpected acci-
dents. Try to keep the waist belt low to
the buttock.
For the sake of safety, the shoulder
belt should not be placed under the arm.
Two Point Type Seat Belt
1. Fasten the Seat Belt
Sit in the seat upright against the seatback with
the tab inserted into the buckle beside the seat.
After the tab is inserted into the buckle, a click
will be heard. Retract the excessive part of the
seat belt and adjust the position of the seat belt.
You can simply pull the unfixed end of the seat
belt to retract it. You must keep the waist belt
low to buttock (do not fasten it to waist and
then adjust the seat belt to proper position).
Advertisement
Table of Contents
