Table of Contents
Advertisement
103
Part I
D
Fold the warning triangle
1. Press the protrusion of the warning triangle
along the direction of arrow D to fold the
reflector triangle.
2. Then rotate the bracket along the direction
of E to fold the warning triangle.
Warning
The warning triangle should be placed
at least 100 meter away from the rear of
the car and secured.
36. Jack
When jacking up the vehicle, support the jack on
E
the position shown in the illustration where there
are wedge plates on both sides of it.
The jack is placed in the trunk right side trim
plate. Open the right trunk door, rotate the
jack screw to make it fully closed and then
you can take out the jack from the bracket.
Support the jack on the right position.
When jacking up the vehicle, follow
the following instructions to reduce the
chance of body injury:
B
A
Warning
Do not have any part of your
body positioned under the jacked-up
vehicle, otherwise it may result in body
injury.
When jacking up the vehicle, do not
crank or start the engine.
When placing the vehicle on level
surface, make sure that the park brake is
applied and the transmission is set to "P"
position (AT) or reverse range (MT). Block
the wheel in the diagonal direction of the
wheel to be replaced.
Make sure the jack is placed on the
right support point. Jacking up the vehicle
at the wrong place may result in the dam-
age or rollover of the vehicle and cause
body injury.
Do not jack up the vehicle if there is
anyone in it.
When jacking up the vehicle, do not
place any object on or under the jack.
Advertisement
Table of Contents
