Zeiss S7 / OPMI VISU 160 Instructions For Use Manual page 78

System Overview
Page 78
Control panel
1 LED display
Display of the set values for lamp brightness or motor speed (for focusing,
zoom, Y-Y coupling).
2 Four LEDs
for assigning the LED display to the function selected via arrow keys (4):
lamp brightness or motor speed (for focusing, zoom, X-Y coupling). Only
one diode is lit at a time.
3 Plus / minus keys
for increasing or decreasing the value of the function selected using the
arrow keys (4). The following setting options are available:
Lamp brightness
Adjustment range: 0.1 to 1.5. Level 0.1 corresponds to the lowest, level
1.5 to the highest lamp brightness.
Motor speed
Adjustment range: 1...10. Level 1 corresponds to the lowest, level 10 to
the highest motor speed.
4 Arrow keys
for selecting one of the following functions: lamp brightness, motor speed
of zoom, focusing or X-Y coupling. The relevant LED is lit.
The value set is saved after 10 seconds and displayed the next time the
system is started.
If no entry is made via the arrow or plus/minus keys, the system will switch
to the lamp brightness display after 15 seconds at the latest.
5 Power switch
This switch is used to switch the system on and off. When the system has
been switched on, the green lamp in the switch is lit.
The power switch also contains an automatic circuit breaker. In the event
of a short inside the system, the circuit breaker is activated and switches
off the system.
S7 / OPMI VISU 160
Version 6.0
G-30-1528-en