Table of Contents
Advertisement
Preparations for use
Relocating the S7 floor stand
CAUTION
CAUTION
Page 140
Risk of crushing - mind your fingers!
Fingers may be crushed in the areas marked with the "Risk of crushing" label.
• Do not touch these areas while the system is being moved or brought
into its working / transport position.
Risk of toppling during transportation of the system!
If the following precautions are not observed, the system may topple over
and injure persons!
• Use the grab handle for transporting the stand.
• Pay attention to the height of doorways when passing through.
• Avoid collisions of any kind.
• Be extremely careful when moving over sloped surfaces.
• Do not park the stand on a sloped surface.
Please observe the following points when relocating the stand:
• Turn off the device at the power switch.
1
• Remove the power plug from the wall socket.
2
• Move the suspension arm into its transport position (see illustration on the
right).
3
• Wind up the foot control panel cable on one of the cable holders (2), and
hang up the foot control panel on the holder (3).
• Wind up the power cord on the other cable holder (2).
• Release all the locking tabs (4) or the casters.
• Hold the device by the grab handle (1) and carefully push it into its new
4
position. Ensure the device is standing on even ground.
• Press at least three of the locking tabs (4) and make sure that the stand is
no longer able to move away by itself.
The mass may be underestimated as the suspension system can be moved
smoothly. Therefore, move the suspension system slowly and carefully!
S7 / OPMI VISU 160
Version 6.0
G-30-1528-en
Advertisement
Chapters
Table of Contents
