Controls, Displays, Connections - Zeiss S7 / OPMI VISU 160 Instructions For Use Manual

System Overview

Controls, displays, connections

1
Page 56
1 Securing screw
2 X-Y coupling
3 Actuator button
– Recenters the X-Y coupling.
– Resets the focus to its initial position in the focusing range
Press this button to start the recentering movement. To stop this move-
ment, press the button again.
You can also stop the recentering movement by briefly tipping on one of
the direction keys on the foot control panel.
4 Cable and light guide clip
5 Carrier arm with tilt device
6 Knob
for setting the tilt angle of the surgical microscope;
+90° in the direction of the surgeon,
-90° in the opposite direction.
7 Arrows indicating the focusing range
If the dot is located between the two arrow tips, the focusing system of
the surgical microscope is in its initial position.
When using a wide-angle observation system
With the wide-angle observation system swung out of the beam path, always
position the microscope body in such a way that index dot (1) for the micro-
scope's focus is in the middle of triangle (2) of the marking (also see
Page 149).
2
S7 / OPMI VISU 160
Version 6.0
G-30-1528-en