Important Information - Otto Bock Genium X3 Instructions For Use Manual

1 Important information

The functional scope of products with serial numbers SN 2015 25 XXX and higher, or products
that have been serviced or repaired by an authorised Ottobock Service Centre since June 2015,
has been extended.
Extended functional scope:
• Switching to pre-configured MyModes and changing the prosthesis settings by using the
remote control or an app for Smartphones (Cockpit 4X441) (see Page 19, see Page 32)
• Possibility of using an intentional stance function (see Page 24)
• Displays of the current battery level without additional devices (see Page 18)
• Deactivation of feedback and vibration signals (mute mode – see Page 36)
• Stance, sitting, and stairs function can be switched off (see Page 32)
• Bluetooth function can be switched off (see Page 34)
INFORMATION
Remote control function only possible with version 1.0.0.6 or above
Please note that you can only use this and/or the updated knee joint with the 4X350-X3 remote
control in version 1.0.0.6 or higher.
Therefore, check the version of the remote control as follows:
► With the remote control switched on, use the
settings and confirm with the
► Use the and
► Use the and
appears than 1.0.0.6, the remote control must be updated by an authorised Ottobock Ser­
vice Centre.
The function of the remote control with this or the updated knee joint is only pos­
sible with version 1.0.0.6 or higher.
6 | Ottobock
key.
keys to select the menu option Info and confirm this with the key.
keys to select the RC version: 1.0.0.4 menu option. If an older version
keys to select the menu option RC
and