Turning Deep Sleep Mode On/Off Using The Remote Control; Opg Function (Optimised Physiological Gait) - Otto Bock Genium X3 Instructions For Use Manual

2) In the navigation menu, tap the entry "Functions".
3) Tap the entry "Activate Deep Sleep".
4) Follow the on-screen instructions.
→ The activation of deep sleep mode is indicated by a short beep signal and a short vibration
signal, assuming that mute mode (silent mode) is not active.
Deactivating deep sleep mode
1) When deep sleep mode is active for the currently connected prosthesis, the Exit deep sleep
mode button automatically appears when the Cockpit app is started.
2) Tapping this button establishes a connection to the prosthesis and deactivates deep sleep
mode.
INFORMATION: Establishing a connection in deep sleep mode can take up to 30
seconds.
If a prosthesis is in deep sleep mode but not connected to the Cockpit app, a connection to the
prosthesis has to be established (see Page 22).

9.7.2 Turning deep sleep mode on/off using the remote control

Activating deep sleep mode
keys to select the menu option "Device settings" in the main menu and confirm
1) Use the ,
this with the key.
keys to select the menu option Deep sleep and confirm this with the key.
2) Use the ,
→ The activation of deep sleep mode is indicated by a short beep signal and a short vibration
signal. Also the remote control is turned off.
Deactivating deep sleep mode
1) Use the key to activate the remote control.
2) With the key, establish a connection to the prosthesis. Establishing the connection to the
prosthesis deactivates deep sleep mode.
INFORMATION: Establishing a connection in deep sleep mode can take up to 30
seconds.

9.8 OPG function (Optimised Physiological Gait)

INFORMATION
To use this function, it must be enabled by the prosthetist.
The OPG function minimises the prosthesis wearer's prosthetic deviations from a harmonious gait
pattern and promotes more biomechanically correct walking. Selection of this function enables
the following features:
PreFlex
PreFlex ensures the knee is in 4° of flexion at the end of swing phase in preparation for loading
response. This makes initiating stance phase flexion easier and forward movement is less restric­
ted.
Adaptive yielding control
The knee joint has auto-adaptive stance and swing extension resistance. The stance flexion resist­
ance experienced by the user is dependent on the slope or incline when walking downhill. When
walking on a ramp, adaptive yielding control manages flexion depending on the angle of the ramp.
The knee joint flexes slowly if the ramp is flat, and flexes quickly if the ramp is steep.
Dynamic stability control (DSC)
DSC ensures the knee will not release stance resistance during biomechanically unstable static
and dynamic conditions. Constantly checking multiple parameters, DSC ensures the optimally
timed decision for the knee to safely switch from stance to swing. Because DSC is always monit­
Ottobock | 37