Control Elements For Cockpit App - Otto Bock Genium X3 Instructions For Use Manual

→ The "Preparation" screen appears. The serial number of the component should be
entered here.
4) Follow the subsequent instructions on the screen.
5) After the PIN code is entered, a connection to the prosthesis is established.
→ While the connection is being established, 3 beep signals sound and the
appears.
The symbol is displayed when the connection has been established.
→ Once the connection has been established successfully, the data are read from the prosthes­
is. This process may take up to a minute.
The main menu will then appear with the name of the connected prosthesis.
INFORMATION
After the initial connection to the prosthesis has been established successfully, the app will con­
nect automatically each time it is started. No further steps are required.

8.3 Control elements for cockpit app

1
Product
2
1. Basic Mode 2. Golf
4
5
6
100% 1. Basic Mode
1. Call up the navigation menu (see Page 22)
2. Product
The component name can only be changed with the adjust­
change
3
ment software.
3. If connections to more than one component have been
saved, you can switch between the saved components by
tapping the entry change.
4. MyModes configured with the adjustment software.
Switching the mode by tapping the corresponding symbol
and confirming by tapping "OK".
5. Currently selected mode
7
6. Charge level of the component.
8
Component battery fully charged
Component battery empty
9
The current charge level is also displayed in %.
7. Display and name of the currently selected mode (e.g. 1.
Basic Mode)
8. Mute mode is activated
9. Connection to component has been established
Connection to component has been interrupted. The app
is attempting to re-establish the connection automatically.
symbol
Ottobock | 21