Turning Bluetooth On The Prosthesis On/Off; Switching Bluetooth Off/On Using The Cockpit App - Otto Bock Genium X3 Instructions For Use Manual

Parameter
Volume
The following parameters can be modified in MyMode "Brake knee":
Parameter
Stance function
Pitch
Volume

9.4 Turning Bluetooth on the prosthesis on/off

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by
connecting/disconnecting the Bluetooth battery charger. Bluetooth is then turned on for approx.
2 minutes. During this time, the app must be started and used to establish a connection. If
required, Bluetooth on the prosthesis can be switched on permanently afterwards (see
Page 34).
INFORMATION
Basic mode (mode 1) has to be active to turn off Bluetooth. If a MyMode is activated, one has to
switch to basic mode to turn off Bluetooth.

9.4.1 Switching Bluetooth off/on using the cockpit app

Switching off Bluetooth
1) When the component is connected, tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Functions".
3) Tap the entry "Deactivate Bluetooth".
4) Follow the on-screen instructions.
34 | Ottobock
Adjustment App/remote
software control
range adjustment
range
0 – 4 0 – 4
Adjustment App/remote
software control
range adjustment
range
0 – 180 +/- 20
1000 Hz – 1000 Hz –
4000 Hz 4000 Hz
0 – 4 0 – 4
Meaning
Volume of beep signal for confirma­
tion tones (e.g. when checking the
charge level, switching MyModes).
The "0" setting deactivates the aud­
ible feedback signals. However, warn­
ing signals in case of errors are still
generated.
Meaning
Basic resistance for the knee joint
without load
Pitch of beep signal for confirmation
tones
Volume of beep signal for confirma­
tion tones (e.g. when checking the
charge level, switching MyModes).
The "0" setting deactivates the aud­
ible feedback signals. However, warn­
ing signals in case of errors are still
generated.