4) Follow the subsequent instructions on the screen.
5) After the PIN code is entered, a connection to the prosthesis is established.
→ While the connection is being established, 3 beep signals sound and the
appears.
The
symbol is displayed when the connection has been established.
→ Once the connection has been established successfully, the data are read from the pros
thesis. This process may take up to a minute.
The main menu will then appear with the name of the connected prosthesis.
INFORMATION
If establishing a connection to a component is not possible, perform the following steps:
►
Delete the component from the Cockpit app if applicable (see the section "Deleting a com
ponent")
►
Add the component again in the Cockpit app (see the section "Adding a component")
8.4.2 Deleting a component
1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Tap the
symbol under the component you want to delete.
→ The component is deleted.
8.4.3 Connecting component with multiple devices
The connection for a component can be stored on more than one device. However, only one
device or remote control can be connected to the component at one time.
If there is an existing connection between the component and a different device, the following
information appears while the connection is being established with the current device:
Connect to this component?
Component was connected to
another device.
Establish connection?
Cancel
9 Use
9.1 Movement patterns in basic mode (mode 1)
9.1.1 Standing
Knee control through high hydraulic resistance and static alignment.
A stance function can be enabled by the prosthetist. Please see the following
section for further information on the stance function.
► Tap the OK button.
→ The connection to the last connected device is broken off
and established with the current device.
OK
symbol
Ottobock | 23