[Pr. Pt26_Function Selection T-2 (*Top2)]; [Pr. Pt29_Function Selection T-3 (*Top3)] - Mitsubishi Electric MR-J5-G User Manual

[Pr. PT26_Function selection T-2 (*TOP2)]

Initial value
00000000h
[Pr. PT26.4_Touch probe latch position selection]
Initial value
0h
Select the reflecting patterns of [Pr. PA14 Travel direction selection] and [Pr. PT08 Homing position data] to the latch position
in the touch probe function.
0: Reflect only some of the patterns of [Pr. PA14]
2: Reflect all the patterns of [Pr. PA14] and [Pr. PT08]
The reflecting patterns are as follows.
*1
[Pr. PT26.4] Trigger
[Touch probe function (Obj.
60B8h)]
[Touch probe function 2
(Obj. 2DE8h)]
0 0 (Triggered by inputting touch
probe)
1 (Triggered at the zero point of
the encoder)
2 0 (Triggered by inputting touch
probe)
1 (Triggered at the zero point of
the encoder)
*1 The trigger corresponds to bit 2 or bit 10 of [Touch probe function (Obj. 60B8h)] or bit 2 of [Touch probe function 2 (Obj. 2DE8h)]. The
applicable object differs depending on the touch probe device being used.

[Pr. PT29_Function selection T-3 (*TOP3)]

Initial value
00000000h
[Pr. PT29.0_Device input polarity 1]
Initial value
0h
Select the proximity dog input polarity.
0: Dog detection with off
1: Dog detection with on
Setting range
Refer to the relevant detail No.
Setting range
0h to 2h
[Pr. PT01.2 Unit for position
data]
0 (mm), 1 (inch), 3 (pulse)
2 (degree)
0, 1, 3
2
0, 1, 3
2
0, 1, 3
2
Setting range
Refer to the relevant detail No.
Setting range
Refer to the text
1.9 Positioning control setting servo parameters group ([Pr. PT_ _ ])
Setting method
Each axis
Ver.
C4
Reflecting the setting
value of [Pr. PA14]








Setting method
Each axis
Ver.
A0
1 SERVO PARAMETER DETAILS
Ver.
Refer to the relevant detail No.
Reflecting the setting
value of [Pr. PT08]








Ver.
Refer to the relevant detail No.
163
1