Removing and Installing the Front Covers and Bezel Extenders on Original Cisco 12000 Series Routers
Installing the Front Covers
Step 1
Step 2
Step 3
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
7-4
Refer to
Figure 7-1
and use the following procedure to install the front covers.
Hold the upper blower module front cover by its outside edges and align the ball
studs with the ball stud clips on the front of the chassis.
Push the front cover into the ball stud clips and the front cover is flush with the
front of the chassis.
Repeat Step 1 and Step 2 for the remaining front covers.
Chapter 7
Maintaining the Router
OL-11495-01