Removing The Front Covers From Cisco 12016 Original Series Routers - Cisco 12416 Installation And Configuration Manual

Pre-Installation Considerations and Requirements
Removing the Front Covers from Cisco 12016 Original Series
Routers
Note
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
3-4
The chassis front covers for the power shelf and upper blower module, upper card
cage, lower card cage, and lower blower module are fastened to the chassis by ball
studs on the front of the chassis
The power shelf and upper blower module front cover is packaged in the
accessory kit to permit the foam shipping cap to fit securely on the top of the
router, and to protect the router without damaging the front cover.
To remove a cover, grasp the outside edges of the cover and pull it straight out to
detach it from the front of the chassis.
Chapter 3
(Figure 3-1).
Installing the Router
OL-11495-01