Cisco 12416 Installation And Configuration Manual page 213

Chapter 4 System Startup and Basic Configuration
Enter the enable command and password (if prompted).
Step 7
Milo> enable
Password: <password>
Milo#
Enter the show startup-config command to display the enabled password in the
Step 8
configuration file.
Milo#
.
.
.
password bambam
Step 9 Enter the configure terminal command to enter global configuration mode:
Milo# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Milo(config)#
Enter the config-register 0xvalue command to change the software configuration
Step 10
register value back to its original value which you noted in Step 1.
Milo(config)# config-register 0xvalue
Milo(config)#
Press Ctrl-Z to exit global configuration mode.
Step 11
Milo(config)# Ctrl-Z
Milo#
Reboot the router and use the recovered password with the enable command to
Step 12
gain access to the router.
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
OL-11495-01
show startup-config
Recovering a Lost Password
4-43