Removing And Installing The Front Cover; Removing The Front Cover; Installing The Front Cover - Cisco XR 12406 Installation Manual

Removing and Installing the Front Cover

Step 1
Step 2
Step 3
Step 4
Removing and Installing the Front Cover

Removing the Front Cover

Installing the Front Cover

Step 1
Step 2
Cisco XR 12406 Router Installation Guide
5-4
Turn off the power switches (AC) or circuit breaker switches (DC) on the PEMs.
Turn off the facility circuit breakers for power source lines connected to the PDU.
When the procedure requires that the router be disconnected from source power:
AC-powered systems—Unplug the AC power cords from the power outlets.
a.
DC-powered systems—Disconnect and remove the source DC wires from the
b.
power connector blocks on the PDU.
Verify that the following conditions:
LEDs on the PEMs are off.
a.
LEDs on the RP, line cards, and alarm cards are off.
b.
LEDs on the blower module are off.
c.
The front cover has release buttons on both sides that give you the flexibility to
open it from either the left side or from the right side. Use the following
procedures to remove and install the front cover.
To remove the front cover, grasp both sides of cover and press both release buttons
simultaneously to release the door from its hinges (see
Use the following procedure to install the front cover.
Align the hinges on each side of the cover with the hinges on each side of the
chassis (see blowout in
Push the front cover until the hinges snap into place.
Figure 5-1)
Chapter 5 Maintaining the Router
Figure 5-1).
OL-13831-01