Connecting Grp Route Processor Cables - Cisco 12416 Installation And Configuration Manual

Chapter 3 Installing the Router

Connecting GRP Route Processor Cables

Figure 3-18 GRP Console and Auxiliary Port Connections
Modem
Console terminal
Caution
Note
OL-11495-01
This section describes how to connect cables to the console, auxiliary, and
Ethernet ports on the GRP. The console and auxiliary ports are both asynchronous
serial ports; any devices connected to these ports must be capable of asynchronous
transmission. For example, most modems are asynchronous devices.
Figure 3-18 shows an example of a data terminal and modem connections.
The ports labeled Ethernet, 10BASE-T, Token Ring, Console, and AUX are safety
extra-low voltage (SELV) circuits. SELV circuits should only be connected to
other SELV circuits.
RP cables are not available from Cisco, but are available from any commercial
cable vendor.
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide

Connecting GRP Route Processor Cables

DB-25 female
DB-25 male
GRP
Auxiliary
port
Console
port
3-31