Using RP Flash Memory Cards
Booting from Flash Memory
Copying Image Files to or From Flash Memory
Caution
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
4-52
To boot from flash memory, the boot field in the software configuration register
(bits 3 through 0) must be set to a value between 2 and 15 (see the
the Software Configuration Register" section on page
Use the following command to enable booting from flash memory.
boot system flash device:filename
Where:
boot system flash device: is slot0:, or slot1:
•
filename is the name of the configuration file
•
Milo# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Milo(config)# boot system flash slot0:myfile1
This section describes how to copy image files to the flash memory SIMM on the
route processor, or to a flash memory card in slot 0 or slot 1.
You cannot copy a new Cisco IOS software image into the onboard flash memory
SIMM (also referred to as bootflash) while the system is running from that
onboard flash memory.
Chapter 4
System Startup and Basic Configuration
4-31).
"Configuring
OL-11495-01