Cisco 12416 Installation And Configuration Manual page 333

Chapter 7 Maintaining the Router
Install the 2500 W power supply
Step 8
a.
To prevent damage to the power shelf backplane connector, do not use excessive
Caution
force when inserting the power supply into its power shelf bay.
b.
c.
Figure 7-24 Installing a 2500 W AC Power Supply
Plug the power supply cable into its AC outlet.
Step 9
Power on the circuit breaker to that AC outlet.
Step 10
After the power-on sequence completes, the (green) PWR OK indicator on the
front of the power supply should light. If the indicator does not light, see the
"Troubleshooting the AC Power Supply Installation" section on page
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
OL-11495-01
Slide the power supply into the bay until it mates with its backplane
connector.
Lift up the ejector handle to hook it over the bottom edge of the power shelf.
Tighten the captive screw to secure the power supply in the shelf.
Pwr Ok Fault
Temp
OC
Removing and Replacing an AC Power Supply
(Figure 7-24):
Pwr Ok Fault
Temp
OC
Pwr Ok Fault
Temp
OC
7-42.
7-41