Chapter 2
Preparing for Installation
GRP Ethernet Port Connections
Note
OL-11495-01
The GRP has the following two types of Ethernet connections
RJ-45 media-dependent interface (MDI)
•
40-pin, D-shell type media-independent interface (MII)
•
Figure 2-13 GRP RJ-45 and MII Ethernet Connections
To repeater
or DTE
RJ-45 cable
To transceiver,
repeater, or DTE
You can use either Ethernet connection, but not both at the same time. Two LEDs
on the GRP front panel indicate which Ethernet port is active. Each connection
supports IEEE 802.3 and IEEE 802.3u interfaces compliant with the 10BASE-T
and 100BASE-TX standards.
The Ethernet port can use either unshielded twisted-pair (UTP) or shielded
twisted-pair (STP) cables. Shielded twisted-pair cables are recommended for sites
at which extremely high immunity to noise is required.
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
MII cable
GRP Port Connection Guidelines
(Figure
2-13):
2-29