Cisco 12416 Installation And Configuration Manual page 230

Using RP Flash Memory Cards
Copying the Running Configuration File from DRAM to a Flash Memory Card
Step 1
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
4-60
Use the following procedure to copy the running configuration file from DRAM
on the RP to a flash memory card.
Enter the copy command in the following form:
copy running-config [slot0:|slot1:]filename
Where:
running-config is the source configuration file in DRAM.
•
[slot0: | slot1:] specifies the destination of the configuration file to be copied.
•
filename is the name of the configuration file.
•
Milo# copy running-config slot0:myfile2
20575008 bytes available on device slot0, proceed? [confirm]
Address or name of remote host [1.1.1.1]?
Loading new.image from 1.1.1.1 (via Ethernet0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!![OK - 7799951/15599616 bytes]
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
Milo#
The exclamation points (!!!) appear as the file is being copied.
•
The C characters signify the calculation of the CRC, which verifies that the
•
file is copied correctly.
Chapter 4 System Startup and Basic Configuration
OL-11495-01