Diag Command Output Examples; Testing Without The Verbose Option - Cisco 12416 Installation And Configuration Manual

Chapter 6 Router Field Diagnostics
Caution

diag Command Output Examples

Caution

Testing Without the verbose Option

OL-11495-01
Do not replace memory components without properly grounding both the board
and yourself.
This section contains output examples using diag commands.
Performing field diagnostics on a line card stops all activity on the line card.
Before the diag command begins running diagnostics, you are prompted to
confirm the request to perform field diagnostics on the line card.
The following example shows the output of diagnostic testing performed on a line
card in slot 7 without the verbose option specified. After the line card passes all
field diagnostic tests, Cisco IOS software automatically reloads on the card.
Note that the total/indiv. timeout set to 2000/600 sec. message indicates that
2000 seconds are allowed to perform all field diagnostics tests, and that no one
test should exceed 600 seconds to complete.
Router# diag 7 source tftp
tftp://192.164.5.4/images/c12k-fdiagsbflc-mz.120-25.S
Running DIAG config check
Fabric Download for Field Diags chosen: If timeout occurs, try 'mbus'
option.
Running Diags will halt ALL activity on the requested slot.
award-rp-slot0#
Launching a Field Diagnostic for slot 7
Downloading diagnostic tests to slot 7 via fabric (timeout set to 300
sec.)
5d20h: %GRP-4-RSTSLOT: Resetting the card in the slot: 7,Event:
EV_ADMIN_FDIAG
Loading images/award/c12k-fdiagsbflc-mz from 192.164.1.1 (via
Ethernet0): !!!!!
5d20h: Downloading diags from tftp file
tftp://192.164.1.1/images/award/c12k-fdiagsbflc-mz
!!!!![OK - 13976524 bytes]
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
diag Command Output Examples
[confirm]
6-13