Removing and Replacing an AC Power Supply
To remove and replace an AC power supply, use the following procedure.
You cannot mix power supply types within the chassis. If you plan to replace a
Caution
2000 W power supply from an original system with a newer, 2500 W power
supply, you must replace all of the power supplies and the power shelf (see
Table 7-1 on page
Be sure to notify the appropriate personnel that all routing traffic will stop while
the upgrade takes place.
Step 1
Unplug the power supply cord from its AC outlet.
Power off the circuit breaker assigned to that AC outlet.
Step 2
To ensure that power remains off while you are performing this procedure, tape
Warning
the circuit breaker switch in the off (0) position.
Remove the power supply from the power shelf.
Step 3
•
•
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
7-36
7-30). You must shut down the router to perform the upgrade.
For 2000 W PEM—Go to
For 2500 W PEM—Go to
Chapter 7
Step
4.
Step
5.
Maintaining the Router
OL-11495-01