Cisco 12416 Installation And Configuration Manual page 228

Using RP Flash Memory Cards
Copying the Startup Configuration File from NVRAM to a Flash Memory Card
Step 1
Step 2
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
4-58
Use the following procedure to copy a configuration file from NVRAM to a flash
memory card.
Enter the show bootvar command to display the current setting for the
environmental CONFIG_FILE variable.
Note The environmental CONFIG_FILE variable must point to NVRAM
(system default).
Milo# show bootvar
.
.
.
CONFIG_FILE variable =
Current CONFIG_FILE variable =
.
.
.
Milo#
The absence of any notation following the CONFIG_FILE variable statement as
shown in this example indicates that the environmental variable is pointing to
NVRAM.
Enter the copy command in the following form:
copy startup-config [slot0: | slot1:] filename
Where:
startup-config is the source configuration file in NVRAM.
•
[slot0: | slot1:] specifies the destination of the configuration file to be copied.
•
filename is the name of the configuration file.
•
Chapter 4 System Startup and Basic Configuration
OL-11495-01