Removing And Installing A Chassis - Cisco 12416 Installation And Configuration Manual

Removing and Installing a Chassis

Step 11

Removing and Installing a Chassis

Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
7-88
Run the show gsr command to verify that the new switch fabric cards are detected
by the system.
The show gsr command output varies slightly between each switch fabric
Note
card set.
The switch fabric upgrade kit does not include a new label to identify the
upgraded router model, so the label on the side of the chassis still identifies the
chassis as a Cisco 12016 or Cisco 12416 router.
You can identify an upgraded router by:
Reading the numbers on the switch fabric card labels.
•
Using the show gsr command to generate the switch fabric card identification
•
numbers. Table 7-3
card number on the identification label.
Table 7-3 Identifying Switch Fabric Cards
Router Model
Cisco 12016 router
Cisco 12416 router
Cisco 12816 router
This section provides the procedures to remove and replace a chassis. You may
need to perform this procedure to replace a defective chassis or move it to another
location. These instructions include the steps directing you to removal and
replacement instructions for individual components such as power supplies and
line cards.
lists the router model and the corresponding switch fabric
Switch Fabric Card Identification Label
SFC-80 and CSC-80
SFC-320 and CSC-320
SFC-1280 and CSC-1280
Chapter 7 Maintaining the Router
OL-11495-01