Installing Rack-Mount Brackets On The Front Of The Chassis - Cisco 7301 Installation And Configuration Manual

Chapter 2 Rack-Mounting, Tabletop Installation, and Cabling

Installing Rack-Mount Brackets on the Front of the Chassis

Figure 2-3
1
Determine whether you want the chassis to be flush-mounted or recessed.
being attached for a front rack-mount. Depending on the bracket holes you use, the router will protrude
or be recessed in the rack.
To install the rack-mount and cable-management brackets on a Cisco 7301 router for a front rack-mount
configuration, complete the following steps:
Locate the threaded holes in the front sides of the chassis.
Step 1
Align the rack-mount bracket (1) to the side of the router. Depending on which set of rack-mount bracket
Step 2
holes you choose to use to attach the rack-mount bracket to the router, the chassis will either be recessed
in the rack, or protrude from the rack.
Insert and tighten the two screws.
Step 3
Repeat Step 1through Step 3 on the other side of the router.
Step 4
This completes the steps for attaching the rack-mount brackets to the Cisco 7301 router.
To install the cable-management bracket, go to the
on page
the Rack" section on page
OL-5418-07
Attaching the Rack-Mount Brackets to the Front of the Chassis
ATM
GIGA BIT ETH
SLO T 1
RJ45 EN
CI SC O 73
01
Rack-mount bracket
2-8. If you are not installing the cable-management bracket, go to the
2-9.
ERN ET 0/0
GIGA BIT ETH
LINK ERN ET 0/1
TX RJ45 EN
GBIC
RX GIGA BIT ETH
LINK ERN ET 0/2
TX RJ45 EN
GBIC
RX
LINK AUX
CON SOL E
TX
GBIC
RX
100 -240 V,
2A, 50/6 0
24V =9A ,
48 - 60V =5A
ALA RM
COM PAC T
FLAS H
STAT US
2
"Attaching the Cable-Management Bracket" section
Cisco 7301 Installation and Configuration Guide
Hz
1
4 screws, 8-18 x .37 in., for use with a 19-inch
rack
4 screws, 8 x .375 in., for use with a
21–23-inch rack
Figure 2-3
"Installing the Chassis in
Installing the Router
2
shows the brackets
2-7