Checking The Software Version Number And Installed Interfaces - Cisco 12416 Installation And Configuration Manual

Cisco IOS User Interface

Checking the Software Version Number and Installed Interfaces

Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
4-26
The following example shows how to configure an ATM line card to use IP.
Configuring interface parameters:
Configuring interface ATM1/0:
Is this interface in use?: yes
Configure IP on this interface?: yes
IP address for this interface: 1.1.1.2
Number of bits in subnet field: 0
Class A network is 1.0.0.0, 0 subnet bits; mask is 255.0.0.0
After you have manually configured the network interface parameters, the RP and
line card interfaces are available for limited use.
To modify the currently saved configuration information, you can enter the
•
setup command at the privileged EXEC mode prompt (
start another system configuration dialog session.
To perform more complex configuration tasks, you can enter the configure
•
terminal command at the privileged EXEC mode prompt (
invokes global configuration mode [
Configuration Mode" section on page 4-27
The show version command displays the Cisco IOS software version number as
well as other information, including the hardware installed in the system, the
names and sources of system image files, and the contents of the software
configuration register.
The following example shows the type of information generated by this command.
Milo# show version
Cisco Internetwork Operating System Software
IOS (tm) GS Software (GSR-P-M), Experimental Version
12.0(20010120:204554) [gha]
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Sat 20-Jan-01 18:34 by ghall
Image text-base: 0x60010950, data-base: 0x61C14000
ROM: System Bootstrap, Version 11.2(17)GS2, [htseng 180] EARLY
DEPLOYMENT RELEA)
BOOTFLASH: GS Software (GSR-BOOT-M), Version 11.2(18)GS4, EARLY
DEPLOYMENT RELE
Getty uptime is 22 hours, 15 minutes
System returned to ROM by reload
Chapter 4 System Startup and Basic Configuration
Milo#
]. See the
Milo(config)#
for more information.
) at any time to
), which
Milo#
"Using Global
OL-11495-01