Fiber Management Installation (Optional) - Alcatel-Lucent 1665 Installation Manual

Equipment and cable installation for 1665 Data Multiplexer
(1665 DMX)

Fiber management installation (optional)

............................................................................................................................................................................................................................................................
Description
This section describes how to install the fiber management pieces that may be shipped
with the bay.
Important!
be extended by at least 2.5 inches beyond the bay upright on each side. This is
typically done using base fillers.
Comcode numbers are in parentheses next to the part number.
Procedure
........................................................................................................................................................................................................................
Locate three spools (106738156), one fiber radius control module (321-1B), one left fiber
1
spool bracket (848919213) and 3 M4 X 6 bracket mounting screws (901340059) for each
shelf being installed.
........................................................................................................................................................................................................................
For each spool, put a nylach fastener through the middle. Then insert a pin halfway
2
through.
Important!
deform the fastener and prevent it from being assembled to the bracket.
........................................................................................................................................................................................................................
Line up the nylach fastener in one of the spools with the large holes on the top arm of the
3
bracket.
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 1, November 2007
If fiber management is to be installed, the width of the bay footprint must
It is very important that the pin is not completely inserted. This will
Fiber management installation (optional)
1 - 2 7