Lnw37, Lnw45, Lnw55)/Oc-12 (Lnw49, Lnw55)/Oc-48 (Lnw55, Lnw62) Low-Speed Sfp Test Procedure - Alcatel-Lucent 1665 Installation Manual

Installation tests
Result:
NE LEDs should be lit on the SYSCTL circuit pack.
The alarm on the SFP module will flash.
........................................................................................................................................................................................................................
5 From the system view click Alarm List to verify that the circuit pack alarm is associated
with the optical port being tested.
........................................................................................................................................................................................................................
Select Configuration -> Update System... -> Update All.
6
Requirement: The flashing FAULT LED should extinguish on the OLIU. There
should be no alarm indications on the 1665 DMX shelf.
........................................................................................................................................................................................................................
From the system view click Alarm List to verify that the circuit pack alarm is cleared.
7
........................................................................................................................................................................................................................
Repeat this entire procedure for each LNW37, LNW45, LNW49, LNW55 or LNW62 SFP
8
equipped in the 1665 DMX shelf.
........................................................................................................................................................................................................................
Replace all protective dust covers on the LNW37, LNW45, LNW49 or LNW62 SFP
9
OLIU connectors (OLIU and LGX), that were removed to perform this procedure.
........................................................................................................................................................................................................................
Check off the appropriate box in
10
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
4 - 4 2
The FAULT LED should begin flashing on the OLIU and only the MN and
S
F T E P S
OC-3 (LNW37, LNW45, LNW55)/OC-12 (LNW49,
LNW55)/OC-48 (LNW55, LNW62) low-speed SFP test
Appendix E, "Installation checklist".
365-372-304R7.1
Issue 1, November 2007
procedure