Alcatel-Lucent 1665 Installation Manual page 164

Powering and initial circuit pack installation for 1665 Data
Multiplexer (1665 DMX)
........................................................................................................................................................................................................................
Check off the appropriate box in
4
E O
N D
........................................................................................................................................................
Install pluggable transmission modules
This section contains the instructions for the installation of the pluggable transmission
modules.
........................................................................................................................................................................................................................
Refer to the engineering job specification. Identify the proper circuit pack type and the
1
port socket being equipped with the pluggable module (SFP). Make sure the transmission
rate (OC3, OC12, 100Base Ethernet or GbE) matches the rate of the SFP. See
G, "Pluggable transmission module
Important!
maintain cleanliness during storage and/or transportation. It is recommended that the
dust plug be kept in place to maintain cleanliness. With proper care and handling,
cleaning the pluggable modules should not be necessary.
........................................................................................................................................................................................................................
Check the ports for cleanliness and clean the pluggable module if necessary. See
2
Appendix B, "Fiber
........................................................................................................................................................................................................................
Insert the pluggable module in the required socket of the circuit pack faceplate, then
3
wiggle the module to verify that it is locked in the socket. See
transmission module
plugs.
........................................................................................................................................................................................................................
Repeat
4
............................................................................................................................................................................................................................................................
2 - 3 4
S
F T E P S
Pluggable modules are shipped with a dust plug installed into the ports to
cleaning".
CAUTION
Never mechanically clean the receive (RX) port. Air blows only should be used
on the receive (RX) port. The receive (RX) port contains a lens for focusing a
wide input. The lens is more easily scratched than cleaned.
installation". Verify that all unused sockets are equipped with dust
Step 1 through Step 3
Appendix E, "Installation
installation".
if more modules need to be installed.
Initial circuit pack installation
checklist".
Appendix
Appendix G, "Pluggable
365-372-304R7.1
Issue 1, November 2007