Alcatel-Lucent 1665 Installation Manual page 159

Powering and initial circuit pack installation for 1665 Data
Multiplexer (1665 DMX)
........................................................................................................................................................................................................................
Install the SFP module per
6
........................................................................................................................................................................................................................
Check off the appropriate box in
7
E O
N D
........................................................................................................................................................
LNW67 (1G SX) installation (optional)
Follow this procedure only if installing LNW67 (1G SX) circuit packs into the 1665 DMX
shelf.
Important!
........................................................................................................................................................................................................................
Refer to the engineering job specification. Identify the proper function group slot (A1, A2,
1
B1, B2, C1, C2, D1, D2) and/or growth slot (G1 or G2) where the LNW67 circuit pack
will be installed.
Important!
only be installed in slot 1 of any function group or growth slot 1.
........................................................................................................................................................................................................................
Remove the LNW67 from the packing material.
2
........................................................................................................................................................................................................................
3 Place the circuit pack into the shelf fn slot as required). Do NOT engage the circuit pack
in the backplane connector.
........................................................................................................................................................................................................................
Install a blank circuit pack into the companion fn circuit pack slot as required.
4
Important!
for cooling.
........................................................................................................................................................................................................................
Repeat
5
equipped with LNW67 circuit packs.
............................................................................................................................................................................................................................................................
365-372-304R7.1
Issue 1, November 2007
Install pluggable transmission modules (p.
S
F T E P S
The LNW67 (1G SX) requires multi-mode fiber.
Unless equipped with LNW59 VLF mains, the LNW67 circuit pack can
Blank circuit packs are required in all unused slots to provide proper air flow
Step 1 through Step 4
Appendix E, "Installation
for each additional function group and/or growth slot to be
Initial circuit pack installation
2-34).
checklist".
2 - 2 9